Air Bed Foundations | Air Mattress Foundations
Our solid wood box foundation is eight inches thick and attractively upholstered in extremely durable fabric. Firm and flat, our foundation provides years of support for your Sleep Better Air Bed while protecting it from the soft spots and slats of traditional box springs. Our foundation or a hard platform surface is recommended for the proper support of your Sleep Better Store mattress.
Please follow these instructions to insure you have a safe foundation for your new mattress system. Here's what's in the box:
STEP 1
Getting started
- Lay the SIDE RAILs and one END BEAM on the floor. Line-up both SIDE RAILs with the channels on the outside the END BEAM.
- Locate the two BOLTs, WASHERs, and WING-NUTs in the plastic bag.
- Insert two BOLTs through the holes found on both outside corners
of the END BEAM. Finally, fit a WASHER and a WING-NUT onto each BOLT
and tighten.
STEP 2
Assembling the center rail
- Place one end of the CENTER RAIL through the middle of the END
BEAM. (There are no bolts necessary to secure this rail to the END
BEAM.)
- Slide the other end of the CENTER RAIL into the middle of the 2nd END BEAM.
- Insert two BOLTs through the holes found on both outside corners
of the END BEAM. Again, fit a WASHER and a WING-NUT onto each BOLT and
tighten, just as in step one.
STEP 3
Assembling the position slats.
- Place the roll of SLATS on top of the wooden structure at one
end. Place the inside of the first SLAT on the outside of the pegs found
at the ends (on top) of the SIDE RAILS. Then, unroll the SLATS across
the top of the foundation and place the inside of the last SLAT outside
of the pegs found on the opposite ends of the SIDE RAILS. (You may have
to pull tight to get them to fit.)
STEP 4
Adding the cover
- Place the FOUNDATION DECK over the foundation then slip the
COVER over the corner edges of the foundation with the fabric side
facing out (don't try to pull the COVER down completely). Work one
corner of the cover down an inch or two at a time. Repeat this process
until the COVER is completely over the foundation. Lift the foundation
onto it's side and pull the draw string tight.
- Your foundation is now complete and ready for use!